A comparison of preload values in gold and titanium dental implant retaining screws

• Published in: SADJ (Houghton) Vol. 69; no. 7; p. 316
• Main Authors: Doolabh, R, Dullabh, H D, Sykes, L M
• Format: Journal Article
• Language: English
• Published: South Africa 01-08-2014
• Subjects: Dental Abutments; Dental Alloys - chemistry; Dental Implant-Abutment Design; Dental Implants; Dental Materials - chemistry; Dental Prosthesis Retention; Dental Restoration Failure; Dental Stress Analysis - instrumentation; Gold Alloys - chemistry; Humans; Materials Testing; Stress, Mechanical; Titanium - chemistry; Torque
• ISSN: 1029-4864

This in vitro investigation compared the effect of using either gold or titanium retaining screws on preload in the dental implant- abutment complex. Inadequate preload can result in screw loosening, whilst fracture may occur if preload is excessive. These are the most commonly reported complications in implant-retained prostheses, and result in unscheduled, costly and time-consuming visits for the patient and the clinician. This study investigated changes in preload generation after repeated torque applications to gold and titanium screws. The test set-up consisted of an implant body, a cylindrical transmucosa abutment, and the test samples of gold and of titanium retaining screws. The implant bodies were anchored using a load cell, and the transmucosal abutments were attached using either gold or titanium retaining screws. A torque gauge was used to apply torque of 20Ncm, 32Ncm, and 40Ncm to the retaining screws. The preloads generated in each screw type were compared at each torque setting, and after repeated tightening episodes. In addition, the effect of applying torque beyond the manufacturers' recommendations was also examined. Gold retaining screws were found to achieve consistently higher preload values than titanium retaining screws. Preload values were not significantly different from the first to the tenth torque cycle. Titanium screws showed more consistent preload values, albeit lower than those of the gold screws. However due to possible galling of the internal thread of the implant body by titanium screws, gold screws remain the retaining screw of choice. Based on the findings of this study, gold retaining screws generate better preload than titanium. Torque beyond the manufacturers' recommendations resulted in a more stable implant complex. However, further investigations, with torque applications repeated until screw breakage, are needed to advise on ideal maintenance protocols.