Measuring queue capacities of IEEE 802.11 wireless access points

• Published in: 2007 Fourth International Conference on Broadband Communications, Networks and Systems (BROADNETS '07) pp. 846 - 853
• Main Authors: Feng Li, Mingzhe Li, Rui Lu, Huahui Wu, Claypool, Mark, Kinicki, Robert
• Format: Conference Proceeding
• Language: English
• Published: IEEE 01-09-2007
• Subjects: Bit rate; Computer science; Delay estimation; Downlink; Internet; Loss measurement; Queueing analysis; Switches; Throughput; Traffic control
• ISBN: 9781424414321; 1424414326
• DOI: 10.1109/BROADNETS.2007.4550522

While queue capacities have a direct impact on loss and latency during congestion, and wireless networks continue to spread in university, corporate and home networks, little is publicly known about the queue capacities of wireless access points (APs). This paper presents and deploys the Access Point Queue (APQ) methodology for externally estimating the queue capacity for a wireless AP. APQ determines the AP saturation point, measures the baseline delay, induces the saturation rate to measure the delay with a full AP queue and computes the queue capacity. APQ is deployed to determine the queue capacities of three commercial class and four residential class APs. The wireless AP queue capacities are shown to be packet-based and to range from 50 packets to over 350 packets. The fact that queue capacities vary so much among devices targeted for the same network configuration suggests future work to determine the most appropriate queue capacity.