A microbolometer-based far infrared radiometer to study thin ice clouds in the Arctic

• Published in: Atmospheric measurement techniques Vol. 9; no. 4; pp. 1817 - 1832
• Main Authors: Libois, Quentin, Proulx, Christian, Ivanescu, Liviu, Coursol, Laurence, Pelletier, Ludovick S, Bouzid, Yacine, Barbero, Francesco, Girard, Éric, Blanchet, Jean-Pierre
• Format: Journal Article
• Language: English
• Published: Katlenburg-Lindau Copernicus GmbH 27-04-2016; European Geosciences Union; Copernicus Publications
• Subjects: Absorption coefficient; Absorptivity; Accuracy; Algorithms; Arctic clouds; Atmosphere; Atmospheres; Atmospheric and Oceanic Physics; Atmospheric conditions; Atmospheric radiation; Cadmium telluride; Calibration; Change detection; Clouds; Clouds (Meteorology); Computer simulation; Downward long wave radiation; Electronic noise; Far infrared radiation; Field of view; Ice clouds; Image acquisition; Infrared radiometers; Instrumentation and Detectors; Noise control; Noise measurement; Noise reduction; Optics; Physical properties; Physics; Pixels; Polar environments; Radiance; Radiation; Radiation measurement; Radiative transfer; Radiometers; Relative humidity; Remote sensing; Resolution; Sensors; Signal to noise ratio; Spectral bands; Temperature; Trends; Water vapor; Water vapour; Arctic region
• ISSN: 1867-8548; 1867-1381; 1867-8548
• DOI: 10.5194/amt-9-1817-2016

A far infrared radiometer (FIRR) dedicated to measuring radiation emitted by clear and cloudy atmospheres was developed in the framework of the Thin Ice Clouds in Far InfraRed Experiment (TICFIRE) technology demonstration satellite project. The FIRR detector is an array of 80 × 60 uncooled microbolometers coated with gold black to enhance the absorptivity and responsivity. A filter wheel is used to select atmospheric radiation in nine spectral bands ranging from 8 to 50 µm. Calibrated radiances are obtained using two well-calibrated blackbodies. Images are acquired at a frame rate of 120 Hz, and temporally averaged to reduce electronic noise. A complete measurement sequence takes about 120 s. With a field of view of 6°, the FIRR is not intended to be an imager. Hence spatial average is computed over 193 illuminated pixels to increase the signal-to-noise ratio and consequently the detector resolution. This results in an improvement by a factor of 5 compared to individual pixel measurements. Another threefold increase in resolution is obtained using 193 non-illuminated pixels to remove correlated electronic noise, leading an overall resolution of approximately 0.015 W m−2 sr−1. Laboratory measurements performed on well-known targets suggest an absolute accuracy close to 0.02 W m−2 sr−1, which ensures atmospheric radiance is retrieved with an accuracy better than 1 %. Preliminary in situ experiments performed from the ground in winter and in summer on clear and cloudy atmospheres are compared to radiative transfer simulations. They point out the FIRR ability to detect clouds and changes in relative humidity of a few percent in various atmospheric conditions, paving the way for the development of new algorithms dedicated to ice cloud characterization and water vapor retrieval.