Comparison of Numerical Simulation Techniques of Ballistic Ceramics under Projectile Impact Conditions

• Published in: Materials Vol. 15; no. 1; p. 18
• Main Authors: Zochowski, Pawel, Bajkowski, Marcin, Grygoruk, Roman, Magier, Mariusz, Burian, Wojciech, Pyka, Dariusz, Bocian, Miroslaw, Jamroziak, Krzysztof
• Format: Journal Article
• Language: English
• Published: Switzerland MDPI AG 21-12-2021; MDPI
• Subjects: Aluminum oxide; Armor; Armor penetration; ballistic impact; Ballistic impact tests; ceramic armor; Ceramics; Computer simulation; Conversion; Criteria; Finite element method; Mapping; Mathematical analysis; Methods; Numerical analysis; numerical simulation; Penetration depth; Projectiles; Simulation; smoothed particles hydrodynamics; ballistic impact; ceramic armor; finite element method; smoothed particles hydrodynamics; numerical simulation
• ISSN: 1996-1944; 1996-1944
• DOI: 10.3390/ma15010018

This article presents an analysis of the effectiveness of available numerical techniques in mapping the characteristic behavior of ballistic ceramics under projectile impact conditions. As part of the work, the ballistic tests were performed on the layered ceramic/steel composite armor and tested with the 7.62 × 39 mm, armor-piercing incendiary (API) BZ projectile. The experimental tests were then mapped using computer simulations. In numerical analyses, four different techniques were used to describe cubic ceramic tiles Al
O
placed on the ARMOX 500T steel backing plate, i.e.,: the Finite Element Method without Erosion (FEM), Finite Element with erosion (FEM + Erosion), Smoothed Particles Hydrodynamics (SPH) and a hybrid method that converts finite elements to SPH particles after exceeding the defined failure criteria (FEM to SPH conversion). The effectiveness of the individual methods was compared in terms of quality (mapping of characteristic phenomena occurring during the penetration process), quantity (bulge height of the backing plate) and time needed to complete the calculations. On the basis of the results of the experiments and numerical simulations, it was noticed that the most accurate reproduction of the phenomenon of ballistic impact of AP projectiles on ceramic/steel composite armor can be obtained by using a hybrid method, incorporating the conversion of finite elements into SPH particles. This method should be used in cases where accuracy of the results is more important than the time required to complete the calculations. In other situations where the purpose of the calculation is not to determine, for example, the exact value of penetration depth but only to observe a certain trend, the FEM method with defined erosion criteria (variant 2), which is more than 10 times faster, can be successfully used.