A traveling wave ultrasonic motor of high torque

• Published in: Ultrasonics Vol. 44; pp. e581 - e584
• Main Authors: Chen, Y., Liu, Q.L., Zhou, T.Y.
• Format: Journal Article
• Language: English
• Published: Netherlands Elsevier B.V 22-12-2006
• Subjects: High torque; Traveling wave ultrasonic motor; Vibration mode; Vibration mode; Traveling wave ultrasonic motor; 43.38.Fx; High torque
• ISSN: 0041-624X; 1874-9968
• DOI: 10.1016/j.ultras.2006.05.055

A traveling wave ultrasonic motor of high torque with a new configuration is proposed in this paper. In the new design, a part of the motor serves as the stator. The rotor is the vibrator consisting of a toothed metal ring with piezoelectric ceramic bonded, which generates ultrasonic vibration. The rotor is in contact with the shell of motor and is driven by the friction between the rotor and the stator. This configuration not only removes the rotor in a conventional type of traveling wave ultrasonic motor but also changes the interaction between the rotor and the stator of the motor so that it improves the output performance of the motor. Although an electric brush is added to the ultrasonic motor, it is easy to be fabricated because of the low speed of motor.
The finite element method was used to compute the vibration modes of an ultrasonic motor with a diameter of 100
mm to optimize the design of the motor. A 9th mode was chosen as the operation mode with a resonance frequency about 25
kHz. According to the design, a prototype was fabricated. Its performance was measured. The rotation speed–torque curves for various frequencies were obtained. The result shows that its stall torque is greater than 4
N
m within a range of 400
Hz. This ultrasonic motor was used to drive the window glass of a mobile car and the result was satisfactory.
In the further the research on the friction material between the stator and the rotor is under way to improve the efficiency of the ultrasonic motor.