Multi-Band RF Planar Sensor Using Complementary Split Ring Resonator for Testing of Dielectric Materials

• Published in: IEEE sensors journal Vol. 18; no. 16; pp. 6596 - 6606
• Main Authors: Ansari, M. Arif Hussain, Jha, Abhishek Kumar, Akhter, Zubair, Akhtar, M. Jaleel
• Format: Journal Article
• Language: English
• Published: New York IEEE 15-08-2018; The Institute of Electrical and Electronics Engineers, Inc. (IEEE)
• Subjects: Air gaps; Complementary split ring resonator (CSRR); Complex permittivity; CSRR array and non-destructive measurements; Destructive testing; Dielectric measurement; Dielectric properties; Dielectrics; Frequencies; Ground plane; Mathematical analysis; Microstrip; Microstrip transmission lines; Microwave sensors; multi-band microwave sensor; Network analysers; Nondestructive testing; Photolithography; Resonant frequencies; Resonant frequency; Resonators; Sensor arrays; Sensor phenomena and characterization; Sensors; Substrates; Unit cell
• ISSN: 1530-437X; 1558-1748
• DOI: 10.1109/JSEN.2018.2822877

In this paper, an attractive multi-band RF planar sensor, suitable for non-destructive testing of dispersive materials, is proposed. The proposed sensor is based on a number of complementary split ring resonator (CSRR) unit cells etched in the ground plane of the microstrip line. Each CSRR unit cell can be represented by a narrow band reject filter with its center frequency corresponding to the resonant frequency of the respective CSRR cell. The proposed technique is used to design the two, three and four band microwave sensors operating at 1.5 GHz, 2.45 GHz, 3.8 GHz, and 5.8 GHz. The distance between the two adjoining CSRRs is minimized for each case without appreciably increasing the inter-cell coupling effect. The transcendental equations required for determining the complex permittivity of the material under test in terms of the resonant frequency are derived from the numerical data obtained using the electromagnetic solver, the CST studio. These numerical equations are then used to obtain the dielectric properties of various test samples, which are measured using the vector network analyzer. The detailed air gap analysis is also performed for checking the accuracy of the designed planar sensor under the real situation. The proposed sensors are fabricated on 0.8 mm thick FR4 substrates using the standard photolithography technique. A number of standard samples are tested using the fabricated sensors in multiple frequency bands, and a good agreement between the obtained results and the data available in literature shows the applicability of the proposed scheme.