Geometry modeling of single track cladding deposited by high power diode laser with rectangular beam spot

• Published in: Optics and lasers in engineering Vol. 100; pp. 38 - 46
• Main Authors: Liu, Huaming, Qin, Xunpeng, Huang, Song, Hu, Zeqi, Ni, Mao
• Format: Journal Article
• Language: English
• Published: Elsevier Ltd 01-01-2018
• Subjects: Full factorial design; Geometry modeling; High power diode laser; Rectangle beam spot; Single track cladding; Rectangle beam spot; Full factorial design; High power diode laser; Geometry modeling; Single track cladding
• ISSN: 0143-8166; 1873-0302
• DOI: 10.1016/j.optlaseng.2017.07.008

•The relationship between the process parameters and geometrical characteristics of the sectional profile for the single track cladding was investigated.•A nonlinear fitting model was used to fit the relationship between the process parameters and geometry parameters.•A circular arc was adopted to describe the geometry profile of the cross-section of the single track cladding.
This paper presents an investigation on the relationship between the process parameters and geometrical characteristics of the sectional profile for the single track cladding (STC) deposited by High Power Diode Laser (HPDL) with rectangle beam spot (RBS). To obtain the geometry parameters, namely cladding width Wc and height Hc of the sectional profile, a full factorial design (FFD) of experiment was used to conduct the experiments with a total of 27. The pre-placed powder technique has been employed during laser cladding. The influence of the process parameters including laser power, powder thickness and scanning speed on the Wc and Hc was analyzed in detail. A nonlinear fitting model was used to fit the relationship between the process parameters and geometry parameters. And a circular arc was adopted to describe the geometry profile of the cross-section of STC. The above models were confirmed by all the experiments. The results indicated that the geometrical characteristics of the sectional profile of STC can be described as the circular arc, and the other geometry parameters of the sectional profile can be calculated only using Wc and Hc. Meanwhile, the Wc and Hc can be predicted through the process parameters.