The effect of melt thermal-rate treatment on precipitation hardening and mechanical properties of Al–Si–Mg alloys

• Published in: Journal of materials research and technology Vol. 33; pp. 2704 - 2717
• Main Authors: Lee, Sang-Ik, Kayani, Saif Haider, Lee, Yoon-Ho, Kim, Byung-Joo, Euh, Kwangjun, Lee, Je-In, Cho, Young-Hee
• Format: Journal Article
• Language: English
• Published: Elsevier B.V 01-11-2024; Elsevier
• Subjects: Al-10Si-0.35 Mg alloy; Precipitation hardening; Tensile strength; Thermal rate treatment; Thermal rate treatment; T5; Al-10Si-0.35 Mg alloy; Precipitation hardening; Tensile strength
• ISSN: 2238-7854
• DOI: 10.1016/j.jmrt.2024.09.186

In this study, we investigate the age-hardening behavior and mechanical properties of direct chill (DC)-cast Al–10Si-0.35 Mg alloys subjected to melt thermal rate treatment (TRT). Our findings reveal that TRT refines the microstructure and precipitation morphology. Grain analysis indicates the prevalence of twin dendritic grains in both TRT and non-TRT (NTRT) alloys during casting, with the TRT billet exhibiting smaller grains. The microstructural analysis demonstrates that TRT reduces the size of secondary dendrite arm spacing and eutectic phases while ensuring a uniform distribution of intermetallic particles. The precipitation mechanism in both alloys remains consistent, with the TRT alloy exhibiting a higher density of fine precipitates. Additionally, we observe a novel coprecipitation mechanism of Si and β″ phase, attributed to a lower misfit between (003)β″ and (011)Si compared to that between (003)β″ and (0 2‾ 0)Al. Furthermore, the TRT alloy displays slower precipitation kinetics due to homogeneous solute distribution, resulting in higher activation energy for precipitation nucleation. Consequently, a single age-hardening peak is observed in TRT alloys during aging. TRT alloys exhibit higher hardness and tensile strength after artificial aging at 190 and 210 °C, while maintaining comparable elongation to NTRT alloys. Theoretical calculations of precipitation strengthening also show higher values for TRT alloys, consistent with experimental results. Thus, our findings comprehend the underlying mechanisms of melt treatments crucial for improving precipitation hardening behavior and mechanical properties of Al–Si–Mg alloys.
[Display omitted]