High spatial resolution laser cavity extinction and laser-induced incandescence in low-soot-producing flames

• Published in: Applied physics. B, Lasers and optics Vol. 120; no. 3; pp. 469 - 487
• Main Authors: Tian, B., Gao, Y., Balusamy, S., Hochgreb, S.
• Format: Journal Article
• Language: English
• Published: Berlin/Heidelberg Springer Berlin Heidelberg 01-09-2015
• Subjects: Engineering; Extinction; Holes; Laser beams; Laser cavities; Laser induced incandescence; Lasers; Optical Devices; Optics; Photonics; Physical Chemistry; Physics; Physics and Astronomy; Quantum Optics; Soot; Spatial resolution; Volume fraction; Soot Concentration; Soot Particle; Tunable Diode Laser Absorption Spectroscopy; Soot Volume Fraction; Flame Height
• ISSN: 0946-2171; 1432-0649
• DOI: 10.1007/s00340-015-6156-3

Accurate measurement techniques for in situ determination of soot are necessary to understand and monitor the process of soot particle production. One of these techniques is line-of-sight extinction, which is a fast, low-cost and quantitative method to investigate the soot volume fraction in flames. However, the extinction-based technique suffers from relatively high measurement uncertainty due to low signal-to-noise ratio, as the single-pass attenuation of the laser beam intensity is often insufficient. Multi-pass techniques can increase the sensitivity, but may suffer from low spatial resolution. To overcome this problem, we have developed a high spatial resolution laser cavity extinction technique to measure the soot volume fraction from low-soot-producing flames. A laser beam cavity is realised by placing two partially reflective concave mirrors on either side of the laminar diffusion flame under investigation. This configuration makes the beam convergent inside the cavity, allowing a spatial resolution within 200 μm, whilst increasing the absorption by an order of magnitude. Three different hydrocarbon fuels are tested: methane, propane and ethylene. The measurements of soot distribution across the flame show good agreement with results using laser-induced incandescence (LII) in the range from around 20 ppb to 15 ppm.