Waste to Energy: Calorific Improvement of Municipal Solid Waste through Biodrying

• Published in: Environmental and Climate Technologies Vol. 25; no. 1; pp. 176 - 187
• Main Authors: Zaman, Badrus, Samadikun, Budi Prasetyo, Hardyanti, Nurandani, Purwono, Purwono
• Format: Journal Article
• Language: English
• Published: Riga Sciendo 01-01-2021; Riga Technical University
• Subjects: Air flow; Air temperature; Biodrying; Calorific; Calorific value; Degradation; Energy; Energy sources; Flow rates; Flow velocity; Fuels; Hemicellulose; Moisture content; Municipal solid waste; Municipal waste management; Nuclear fuels; Reactors; Refuse derived fuels; Refuse-derived fuel; Solid waste management; Solid wastes; Statistical tests; Waste to energy; Water content
• ISSN: 2255-8837; 1691-5208; 2255-8837
• DOI: 10.2478/rtuect-2021-0012

Municipal solid waste (MSW) is an energy resource with sufficient energy/calorific value, making it a suitable substitute for fuel. This study investigated the effect of air flow rate on the MSW calorific value, the hemicellulose content, and the MSW degradation rate in a biodrying process. Four biodrying reactors equipped with flowrate and temperature recorders were used in the study. The air flow rate was varied as follows: 0 L/min/kg, 2 L/min/kg, 4 L/min/kg, and 6 L/min/kg, corresponding to reactors R1, R2, R3, and R4, respectively. The calorific value, water content, hemicellulose content, organic C content, and total N were measured on day 1, day 15, and day 30. The results showed that the biodrying process could increase the calorific value by 55.3 %, whereas the control reactor could increase the calorific value by only 4.7 %. The highest calorific value was 17.63 MJ/kg, at an air flow rate of 4 L/min/kg. The air flow rate had a significant effect on increasing the calorific value (sig.<0.05). The highest temperature in the biodrying process was 41 °C. The final MSW moisture content was 27.28 %, resulting from R4. According to the statistical test results, the air flow rate had a significant influence on the water content parameters. Hemicellulose degradation due to air flow rate reached 80–85 %. The air flow rate did not significantly influence the hemicellulose degradation (sig.>0.05). The biodrying process is the suitable method to increase the calorific value of MSW while reducing its water content; thus, the process promotes the realization of waste to energy as refuse-derived fuel.