Search Results - "Routbort, J. L."

Refine Results
  1. 1

    Residual stresses, interfacial adhesion and tribological properties of MoN/Cu composite coatings by Pappacena, K.E., Singh, D., Ajayi, O.O., Routbort, J.L., Erilymaz, O.L., Demas, N.G., Chen, G.

    Published in Wear (08-03-2012)
    “…► Tribological properties of MoN/Cu coatings assessed. ► Residual stresses directly affect coating adhesion and wear resistance. ► Copper addition weakens…”
    Get full text
    Journal Article
  2. 2

    High-temperature deformation of amorphous AlPO4-based nano-composites by GUTIERREZ-MORA, F, GORETTA, K. C, SINGH, D, ROUTBORT, J. L, SAMBASIVAN, S, STEINER, K. A, ADABIE, J, RANGAN, K. K

    “…High-temperature compressive deformation of an amorphous aluminium phosphate nano-composite was investigated at 1200-1300 C. Microstructural and XRD…”
    Get full text
    Journal Article
  3. 3

    Evaluation of scuffing behavior of single-crystal zirconia ceramic materials by Lorenzo-Martin, C., Ajayi, O.O., Singh, D., Routbort, J.L.

    Published in Wear (10-09-2007)
    “…Scuffing, described as sudden catastrophic failure of lubricated sliding surfaces, is usually characterized by a sudden rapid increase in friction,…”
    Get full text
    Journal Article Conference Proceeding
  4. 4

    Microstructure and properties of ceramics and composites joined by plastic deformation by Goretta, K.C., Singh, D., Chen, Nan, Gutierrez-Mora, F., de la Cinta Lorenzo-Martin, M., Dominguez-Rodriguez, A., Routbort, J.L.

    “…A review is presented of the design of suitable materials systems for joining by high-temperature plastic deformation, details of the joining techniques,…”
    Get full text
    Journal Article Conference Proceeding
  5. 5

    Tribo-mechanical etching of structural ceramic materials during lubricated severe sliding contact by Lorenzo-Martin, C., Ajayi, O.O., Erck, R.A., Routbort, J.L.

    Published in Wear (15-06-2009)
    “…An unusual phenomenon has been observed in the contact area on the surfaces of three structural ceramic materials that were subjected to severe lubricated…”
    Get full text
    Journal Article Conference Proceeding
  6. 6

    High-temperature mechanical properties of anode-supported bilayers by Gutierrez-Mora, F, Ralph, J.M, Routbort, J.L

    Published in Solid state ionics (02-08-2002)
    “…Mechanical properties of a porous substrate of 40 vol.% Ni–60 vol.% yttria-stabilized zirconia (YSZ), a Ni–YSZ functional layer, and a YSZ electrolyte layer…”
    Get full text
    Journal Article
  7. 7

    High-temperature deformation behavior in SrTiO3 ceramics by SINGH, D, LORENZO-MARTIN, M, CHEN, G, GUTIERREZ-MORA, F, ROUTBORT, J. L

    “…The high-temperature deformation behaviour of a polycrystalline SrTiO3 ceramic (6 micron grain size) was investigated at 1200-1345 C in an argon atmosphere…”
    Get full text
    Conference Proceeding Journal Article
  8. 8

    Solid-particle erosion of directionally solidified Al2O3–ZrO2 (Y2O3) eutectics by Goretta, K.C., Peña, J.I., Orera, V.M., Chen, Nan, Singh, D., Routbort, J.L.

    Published in Wear (04-02-2010)
    “…Resistance to solid-particle erosion was studied by measuring individual damage sites in directionally solidified Al2O3–ZrO2 (Y2O3) eutectics that contained…”
    Get full text
    Journal Article
  9. 9

    Deformation behavior and joining of a MgF2 optical ceramic by LORENZO-MARTIN, C, SINGH, D, JOHNSON, J, ROUTBORT, J. L

    “…The compressive deformation behaviour of a polycrystalline magnesium fluoride (MgF2) ceramic was investigated at temperatures from 760 to 830 C in an argon…”
    Get full text
    Conference Proceeding Journal Article
  10. 10

    Joining alumina/zirconia ceramics by Goretta, K.C, Gutierrez-Mora, F, Picciolo, J.J, Routbort, J.L

    “…Dense compacts consisting of 40 vol.% Al 2O 3–60 vol.% 3 mol% Y 2O 3-stabilized ZrO 2 (YSZ) were joined with an interlayer of 50 vol.% Al 2O 3–50 vol.% YSZ. A…”
    Get full text
    Journal Article
  11. 11

    Erosion of geopolymers made from industrial waste by Goretta, K C, Gutierrez-Mora, F, Singh, D, Routbort, J L, Lukey, G C, van Deventer, J S J

    Published in Journal of materials science (01-05-2007)
    “…Solid-particle erosion studies were conducted on geopolymers derived from various combinations of granulated blast-furnace slag, flyash, sand, clay, and rock…”
    Get full text
    Journal Article
  12. 12

    Solid-particle erosion of an anodized Mg alloy by Goretta, K.C., Cunningham, A.J., Chen, Nan, Singh, D., Routbort, J.L., Jr, R.G. Rateick

    Published in Wear (10-04-2007)
    “…Solid-particle erosion studies were conducted on a hardened Mg alloy (WE43A-T6) and the same alloy that had been anodized to produce a ≈12 μm oxide layer…”
    Get full text
    Journal Article
  13. 13

    Influence of internal stresses in superplastic joining of zirconia toughened alumina by Gutierrez-Mora, F., Goretta, K.C., Majumdar, S., Routbort, J.L., Grimdisch, M., Dominguez-Rodriguez, A.

    Published in Acta materialia (01-08-2002)
    “…Joints between various compositions of 3 mol% Y 2O 3-stabilized ZrO 2/Al 2O 3 composites have been produced by superplastic flow at 1350 °C and strain rates of…”
    Get full text
    Journal Article
  14. 14

    Fracture of composite alumina/yttria-stabilized zirconia joints by Gutierrez-Mora, F., Singh, D., Chen, N., Goretta, K.C., Routbort, J.L., Majumdar, S.H., Dominguez-Rodriguez, A.

    “…Four-point bend tests have been performed on samples consisting of yttria-stabilized zirconia containing 0–80% alumina joined by plastic deformation to the…”
    Get full text
    Journal Article
  15. 15

    Solid-particle erosion of a geopolymer containing fly ash and blast-furnace slag by Goretta, K.C., Chen, Nan, Gutierrez-Mora, F., Routbort, J.L., Lukey, G.C., van Deventer, J.S.J.

    Published in Wear (01-04-2004)
    “…Solid-particle erosion studies were conducted on a geopolymer derived from fly ash and granulated blast-furnace slag. The erodent particles, 390 μm angular Al…”
    Get full text
    Journal Article
  16. 16

    In situ imaging and strain determination during fracture in a SiC/SiC ceramic matrix composite by Ramirez-Rico, J., Stolzenburg, F., Almer, J.D., Routbort, J.L., Singh, D., Faber, K.T.

    Published in Scripta materialia (01-10-2013)
    “…A combined imaging and microdiffraction technique using high-energy synchrotron X-rays is described and used to reveal microstructure, damage and strain…”
    Get full text
    Journal Article
  17. 17

    Joining of yttria-tetragonal stabilized zirconia polycrystals using nanocrystals by Gutierrez-Mora, F, Domı́nguez-Rodrı́guez, A, Routbort, J.L, Chaim, R, Guiberteau, F

    Published in Scripta materialia (06-08-1999)
    “…In this preliminary work, we have demonstrated that it is possible to produce a strong, clean, pore-free interface in submicrometer-grain-sized Y-TZP by using…”
    Get full text
    Journal Article
  18. 18

    Deformation of perovskite electronic ceramics — a review by Routbort, J.L., Goretta, K.C., Cook, R.E., Wolfenstine, J.

    Published in Solid state ionics (01-04-2000)
    “…Steady-state deformation of several important electronic ceramics, all having a perovskite structure, is reviewed and discussed in terms of their common…”
    Get full text
    Journal Article
  19. 19

    Joining particulate and whisker ceramic composites by plastic flow by Chen, Nan, Gutierrez-Mora, F, Koritala, R.E, Goretta, K.C, Routbort, J.L, Pan, Jinsheng

    Published in Composite structures (01-07-2002)
    “…Joining of bulk ceramics by plastic flow has been demonstrated for several fine-grained ceramics. We have joined, for example, submicrometer 3 mol% Y 2O 3…”
    Get full text
    Journal Article Conference Proceeding
  20. 20

    Effect of Microstructure on High-Temperature Compressive Creep of Self-Reinforced Hot-Pressed Silicon Nitride by Boling-Risser, Martha A., Goretta, K. C., Routbort, J. L., Faber, K. T.

    Published in Journal of the American Ceramic Society (01-12-2000)
    “…An experimental self‐reinforced hot‐pressed silicon nitride was used to examine the effects of microstructure on high‐temperature deformation mechanisms during…”
    Get full text
    Journal Article