Search Results - "Grant Emms"
-
1
Review of the use of air-coupled ultrasonic technologies for nondestructive testing of wood and wood products
Published in Computers and electronics in agriculture (01-05-2017)“…•Wood property measurement and defect detection have been summarized.•ACU parameters are highly influenced by wood properties and defects.•Signal and image…”
Get full text
Journal Article -
2
The damping–modulus relationship in flax–carbon fibre hybrid composites
Published in Composites. Part B, Engineering (15-03-2016)“…The trade-off between the elastic modulus and damping capacity as a function of fibre composition in carbon–flax hybrid composite laminates was investigated…”
Get full text
Journal Article -
3
Non-Destructive Evaluation Techniques and What They Tell Us about Wood Property Variation
Published in Forests (01-09-2019)“…To maximize utilization of our forest resources, detailed knowledge of wood property variation and the impacts this has on end-product performance is required…”
Get full text
Journal Article -
4
Microwave Nondestructive Testing of Wood Anisotropy and Scatter
Published in IEEE sensors journal (01-01-2013)“…A microwave-focused beam transmission measurement is identified as a good candidate for fast, accurate, and affordable industrial wood testing. In this paper,…”
Get full text
Journal Article -
5
Overview and comparison of microwave noncontact wood measurement techniques
Published in Journal of wood science (2010)“…This article presents a comprehensive review of the literature on microwave wood testing, offering a critical comparison of reported methods and techniques…”
Get full text
Journal Article -
6
A novel technique for non-damaging measurement of sound speed in seedlings
Published in European journal of forest research (01-09-2012)Get full text
Journal Article -
7
Review of granular material damping and sound absorption for possible application in the sound insulation of lightweight floors
Published in Journal of Building Engineering (15-11-2024)“…Modern structures incorporating lightweight, low-stiffness floors face challenges for low-frequency impact noise transmission. Using spring isolators or…”
Get full text
Journal Article -
8
Digital image correlation analysis of vertical strain for corrugated fiberboard box panel in compression
Published in Packaging technology & science (01-03-2019)“…This work was aimed at examining the overall contributions to displacement of panels of compressed boxes, such as panel compression strain and flap and crease…”
Get full text
Journal Article -
9
A novel technique for non-damaging measurement of sound speed in seedlings
Published in European journal of forest research (01-09-2012)“…A cross-correlation time-of-flight method for measuring the sound speed in a seedling in a non-destructive and non-damaging way is described. The method uses…”
Get full text
Journal Article -
10
Flanking Transmission Measurements: Part 1- Measurement Techniques
Published in Building acoustics (01-01-2010)“…Recently a series of building acoustics measurements were performed at the BRANZ site in Judgeford, New Zealand. A special four-room test facility was built to…”
Get full text
Journal Article -
11
A Method for Studying Dynamic Sorption Behavior of Small Wood Samples
Published in Drying technology (22-08-2008)“…A method for determining mass changes (∼ 0.0001 g) in small (∼ 4-mm cubes) wood samples using the resonance of small mechanical springs mounted on…”
Get full text
Journal Article -
12
Lightweight Floor/Ceiling Systems with Improved Impact Sound Insulation
Published in Building acoustics (01-06-2010)“…Contrary to common belief, a relatively simple and practical lightweight timber based floor/ceiling can have impact sound insulation superior to that of…”
Get full text
Journal Article -
13
Microwave measurement of wood in principal directions
Published in 2009 IEEE Sensors (01-10-2009)“…This paper reports a new method for broadband microwave wood measurement using a focused beam antenna system that allows the determination of propagation…”
Get full text
Conference Proceeding -
14
Microwave measurement of wood anisotropy
Published in 2011 IEEE Sensors Applications Symposium (01-02-2011)“…This paper reports the findings of an experimental study on wood anisotropy measured using a free space horn/lens antenna system. A brief theoretical overview…”
Get full text
Conference Proceeding -
15
Metal plate lens in a focused beam system for microwave material testing
Published in 2008 Asia-Pacific Microwave Conference (01-12-2008)“…This paper reports an investigation of metal plate lens behavior in the Fresnel region and, in particular, its beam-shaping capabilities. Both numerical…”
Get full text
Conference Proceeding